Advertisement
Factory installed kick boards must face the inside of the goal with the tubular frame on the outside.
1.
Using the 3/8" X 3" Hex Bolts (E), Washer Plate (N), 3/8" Lock Washers (H) and 3/8" Hex Nuts (G)
install a Crossbar Bracket (D) to the inside of each Goal Side (B). See Illustration.
2.
Use the 3/8" X 3" Hex Bolts (E), 3/8" Flat Washers (I), 3/8" Lock Washers (H) and 3/8" Hex Nuts (G)
to assemble both Goal Sides (B) to Crossbar (A) by fitting Crossbar (A) over Crossbar Bracket (D) on
both ends. See Illustration.
3.
In the top holes on both Goal Sides (B) use the 3/8" X 4" Hex Bolts (F), 3/8" Flat Washers (I), 3/8"
Lock Washers (H) and 3/8" Hex Nuts (G) to attach Spreader Frame (C) to Goal Sides (B).
See Illustration.
4.
Use 3/8" X 4" Eyebolts (M), 3/8" Flat Washers (I), 3/8" Lock Washers (H) and 3/8" Hex Nuts (G) in
the bottom holes on both Goal Sides (B) to attach Spreader Frame (C) to Goal Sides (B).
See Illustration.
5.
Once goal is assembled install Net Clips (K) along Crossbar (A) and upright poles on Goal Sides (B)
every 24". The Net Clips (K) are designed to slip into the slot then twisted 90 degrees to attach. Drape
Net (J) over the outside of entire Field Hockey Goal, use the Net Clips (K) and cut pieces of Hook and
Loop Fastening Strap (L) as needed to secure Net (J) into position.
6.
Insert Ground Anchors (O) into the ground directly behind each back corner of the goal and carabiner
clip to 3/8" X 4" Eyebolt (M). Securely anchor movable field hockey goals at ALL times.
Notice:
2
Advertisement
