Table of Contents
Advertisement
____________________________________________________________________________________________
____________________________________________________________________________________________
42S043F
Loosely insert rivets in the following steps. Do not tighten
rivets until instructed to do so.
33. Loosely insert rivets in outer hole spar tab corner hole on
counterclockwise side of next panel. See Figure 2-15.
34. Use two people to carry reflector panel using carrying points
illustrated in Figure 2-10. Lift panel as illustrated in Figure 2-11 and
carry panel as illustrated in Figure 2-12. Do not carry panel as
illustrated in Figure 2-13.
35. Install the panel as before in the next clockwise position on the ribs.
36. Install next three panels as described in steps 30 and 31.
37. Attach next panel as described in steps 33 and 34.
38. Install next three panels as described in steps 30 and 31.
39. Attach next panel as described in steps 33 and 34.
40. Install next three panels as described in steps 30 and 31.
41. Attach next panel as described in steps 33 and 34.
42. Install next panel as described in steps 30 and 31. When installing
this last panel, it may be necessary to push up on each rib and tighten
the strut fasteners to close the gap. After installing the panel, slightly
loosen the strut fasteners again.
43. Install rivets to fasten panels to ribs, starting at hub and working in
ever-increasing concentric circles toward rim.
If the lighting protection kit is being installed, refer to its
installation procedure in the Options Section to install the
bracket to the rim of the reflector during the next step.
44. Install rivets to fasten panel rims to clips on rib ends. There are four
rivets at the end of each rib (see Figure 2-16).
SERIES 8060 6-METER EARTH STATION ANTENNA
INSTALLATION PROCEDURES
NOTE
NOTE
2-23
Advertisement
Table of Contents
