Table of Contents
Advertisement
FOUNDATION INSTALLATION (180° MOUNT)
____________________________________________________________________________________________
12.
PROVISIONS MUST BE MADE TO PROVIDE SUITABLE SUPPORT FOR IFL
WAVEGUIDE EITHER BY BURIED CONDUIT OR OVERHEAD RACEWAY. IF PVC
CONDUIT IS SUPPLIED IT SHALL BE AT LEAST 15.2 CM [6 INCH] DIAMETER
WITH A MINIMUM BEND RADIUS OF 91.5 CM P36 INCHES].
13.
AC POWER CONDUIT FOR ANTENNA MOTORS AND DEICING TO BE SIZED BY
ELECTRICAL CONTRACTOR TO MEET LOCAL, STATE, AND NATIONAL
ELECTRICAL CODES.
14.
EXTERNAL AC POWER DISCONNECT BOX NOT SUPPLIED BY Manufacturer. SOME
LOCAL CODES MAY REQUIRE EXTERNAL UNIT. THE 8861/8862 CONTROLLER
HAS AN INTERNAL MAIN BREAKER/DISCONNECT.
15.
GROUND CABLE PIGTAILS SHALL BE IN PVC CONDUIT AND NOT TIED TO
FOUNDATION REBAR.
16.
DO NOT RUN CONDUIT UNDER ANY ANTENNA OR ACTUATOR SUPPORT AREA.
17.
7.6 CM [3 INCH] DIAMTER CONDUIT WITH A MINIMUM BEND RADIUS OF 91.5
CM [36 INCHES] FOR AZIMUTH ACTUATOR MOTOR POWER.
Figure 4-2. Foundation Plan and Conduit Placement, 6M-180° (Sheet 3 of 8), 512239B
____________________________________________________________________________________________
4-22
SERIES 8060 6-METER EARTH STATION ANTENNA
42S042G
Advertisement
Table of Contents
