Vacuuming Dry Materials; Vacuuming Liquids; Emptying The Drum; Moving The Wet/Dry Vac - RIDGID WD1855BR0 Owner's Manual

SP6825 WD1855BR0 60 Liter PSE
Operation (continued)

Vacuuming Dry Materials

1. The filter must always be in correct
position to reduce the risk of leaks and
possible damage to Vac.
2. Your Wet/Dry Vac comes with the
VF5000 Filter installed. When using
your Vac to pick up very fine dust, it will
be necessary for you to empty the
drum and clean the filter at more
frequent intervals to maintain peak Vac
performance.
NOTE: It is necessary that a dried filter is
used to pick up dry material. If you use
your Vac to pick up dust when the filter is
wet, the filter will clog quickly and be very
difficult to clean. Allow filter to dry out
before storing.

Vacuuming Liquids

IMPORTANT:
1. When picking up small amounts of
liquid the filter may be left in place.
2. When picking up large amounts of
liquid we recommend that the filter be
removed. If the filter is not removed, it
will become saturated and misting may
appear in the exhaust.
3. After using the Vac to pick up liquids, the
filter must be dried to reduce the risk of
possible mildew and damage to the filter.
4. When the liquid in the drum reaches a
predetermined level, the float
mechanism will rise automatically to cut
off air-flow. When this happens, turn off
the Vac, unplug the power cord, and
empty the drum. You will know that the
float has risen because Vac airflow
ceases and the motor noise will become
higher in pitch, due to increased motor
speed.
IMPORTANT: To reduce the risk of
damage to the Vac do not run motor with
float in raised position.
4/20/12 8:57 AM

Emptying the Drum

!
WARNING: To reduce the risk of
back injury or falls, do not lift a Vac
heavy with liquid or debris. Scoop
or drain enough contents out to
make the Vac light enough to lift
comfortably.
1. The Vac comes equipped with a drain
for easy emptying of liquids. Simply
unscrew the drain cap and lift the
opposite side slightly to empty the
drum.
2. Another option is to remove the
powerhead assembly.
3. Lay powerhead assembly aside on a
clean area while emptying drum.
4. Dump the drum contents into the
proper waste disposal container.

Moving the Wet/Dry Vac

Should it become necessary to pick the
Vac up to move it, the handle on the
sides of the dust drum are used to lift.
To maneuver the Vac, the push/pull
handle in the rear of the unit should be
used.
51
Page 51