Futek IPM520 Series Faq

Where can I find the wiring guide for my display?

Correct setup is essential to the proper function of ipm520 series meters. The back of the
meter is shown above. The picture illustrates how the location of the top connection
board (optional board) and the bottom (main) board. The diagrams below show the pin
connections for both the main and optional boards. For the main board, the power cord
will connect in pins 1, 3, and 5. Both the connections between the main board-power
supply and the main board-sensor are shown in the diagram. If you choose to use
Channel 1, the signal wires (on sensor) will connect to the Channel 1 input pins, and the
Excitation wires will match up with the Excitation pins. For Dual Channel systems, if
Channel 2 is preferred the signal wires will connect with pins S and 13. For the D525 and
the D528 (meters using the RS232 connection) there is an optional additional connection
between the meter and a PC unit (see the RS232 Manual).
10 Thomas, Irvine, CA 92618 USA T (949)-465-090 F (949)-465-0905
IPM520 FAQ's
futek@futek.com www.futek.com/support