Page 1
Quick Start Guide PT4500-SDI / PT4700-SDI High Bright Beam Splitter Teleprompter w/ 3G-SDI, HDMI, & VGA What’s Included 1 x Teleprompter Base 1 x Bracket with Glass 1 x Teleprompter Hood with Boot 1 x Monitor 1 x AC Adapter with Cord 1 x PrompterPro Software 1 x Counterweight Set (2 x 2.5 lbs)
Assembly Steps Step 1 Remove the monitor mounts from the teleprompter base using the included larger 4mm hex key to loosen from the 15mm rods. Step 2 Attach the monitor mounts on the back of the monitor’s VESA compatible threads using the 4 included screws and provided 2mm hex key. because we’re filmmakers too www.ikancorp.com | 1.713.272.8822 | sales@ikancorp.com...
Page 3
Step 3 After the monitor mounts are attached, adjust the 15mm rods to accommodate the monitor. Leave about 1 inch of room for the teleprompter bracket. Make sure the 15mm rods go through both set of monitor mounts. Please ensure that all screws are properly tightened after inserting the monitor. *SAFETY NOTE* Make sure to leave at least 2 inches of the rods inside the teleprompter base.
Page 4
Step 5 Once the bracket is in place, tighten the side screw to lock in place. Double check and make sure all the screws are tightened with the included hex keys. Step 6 (optional) Should the teleprompter be too front heavy, you can attach the included counter weight on the back of the teleprompter base. because we’re filmmakers too www.ikancorp.com | 1.713.272.8822 | sales@ikancorp.com...
PT4500-G Replacement Glass for both PT4500-SDI / PT4700-SDI PT15-HB 15” Hight Bright Monitor (for PT4500-SDI) PT17-HB 17” High Bright Monitor (for PT4700-SDI) PT-CASE-V2 Rolling Hard Case for PT4500-SDI / PT4700-SDI Teleprompter because we’re filmmakers too www.ikancorp.com | 1.713.272.8822 | sales@ikancorp.com...