Advertisement
Step 3
After the monitor mounts are attached, adjust the 15mm rods to accommodate the monitor. Leave about 1 inch of room for the teleprompter bracket.
Make sure the 15mm rods go through both set of monitor mounts. Please ensure that all screws are properly tightened after inserting the monitor.
*SAFETY NOTE*
Make sure to leave at least 2 inches of the rods inside the teleprompter base.
Teleprompter Base
Step 4
While sliding the teleprompter bracket into the slot of the teleprompter base pull on the red knob to allow the bracket to fully slide in.
because we're filmmakers too
www.ikancorp.com | 1.713.272.8822 | sales@ikancorp.com
Advertisement
