Advertisement
#2 SPECIFICATIONS
* COUNTER
1 3 COUNTING VERSIONS(FIG 1C,1D); 4 COUNTING SPEEDS(FIG 5A,5B).
1) ONE WAY(UP COUNTING):30,100,300,FLOATING(3000HZ)
2) PHASE IN CYCLE COUNT:15,50,150,FLOATING(2000HZ, CYCLE COUNTx1=2,000 COUNT)
3) PHASE IN EDGE COUNT :15,50,150,FLOATING(1000HZ, EDGE COUNTx4=4,000 COUNT)
2 PRE SCALE FACTOR(DSP): 000.000～999.999(EXCEPT WHEN FLOATING COUNTING SPEED INPUT IS
SELECTED)
3 OPERATION MODES 1 OR 2 PRESET OR INDICATION ONLY
4 RESET: (A)AUTO/MANUAL MODES: N.C.R, 000.000～999.999S ADJUSTABLE FOR AUTO
RESET C.R. MODES.
(B) EXTERNAL RESET.
(C) POWER OFF RESET.
(FOR POWER OFF RESET: DRAW OUT PCB, PLACE MINI JUMPER ON PINS MARKED P.R.)
5 OFFSET(OFST) STARTING COUNT : 00-999999.COUNTER STARTS FROM OFFSET SETTING,
AFTER MANUAL RESETTING THE COUNTER
6 GATE IN:(1) COUNT INHIBIT FOR PHASE IN. (2) CP2 IS GATE IN FOR ONE WAY IN
7 DECIMAL POINT:3 POSITIONS FOR PV,P1,P2,OFST.HOLD [<] USE [uR] TO SELECT DP
8 MINUS(-) SIGN: THE DP OF LEAST SIGNIFICANT DIGIT ACT AS A MINUS (-) SIGN
* TIMER
1 4 TIMER RANGES & ACCURACY: (AT 25oC)
1) 9999H59M: +-0.1S+-50PPM/oC
2) 9999M59S: +-1mS+-50PPM/oC
3) 99999.9S: +-1mS+-50PPM/oC
4) 999.999S: +-1mS+-50PPM/oC
2 1 OR 2 PRESET OR TWIN PRESET RE-CYCLE TIMER (FIG 2) OR INDICATION ONLY
3 OFFSET (OFST) TIMING START: 0～999999. TIMER STARTS FROM OFST,
INSTEAD OF 0 AFTER ANNUAL RESETTING THE TIMER
4 RESET: (A)AUTO/MANUAL MODES: N.C.R, 000.000～999.999S ADJUSTABLE FOR AUTO
RESET C.R. MODES.
(B) EXTERNAL RESET.
(C) POWER OFF RESET.
(POWER OFF RESET: DRAW OUT PCB, PLACE MINI JUMPER ON PINS OF P.R.)
5 GATE IN: CP2 IS GATE IN, CP2 HIGH IS TIMING INHIBIT
#3 MODEL PROGRAMMING (FOR COUNTER/TIMER ONLY, USE [<]+[^]) FIG 1-2
1 HOLD SHIFT [<] THEN PRESS UP [^] TO DISPLAY MODE.
2 USE UP [^] TO SELECT REQUIRED MODE.
3 PRESS [M] RETURN TO PV AFTER MODE SELECTED.
WHEN CP1 COUNT BECOMES LESS THAN CP2 METER WILL NOT SHOW MINUS.
2/4
INSTEAD OF 0,
Advertisement
