Desa BLP30 Owner's Manual page 4

ASSEMBLY
1. Remove screw from top of fan guard (see
Figure 3). Discard screw.
2. Insert nut clip (provided with handle) with
flat side facing up through slot in top of shell.
Align holes in nut clip with screw hole behind
slot in top of shell (see Figure 4).
3. Place handle over hole and clip. Insert two
screws (provided with handle) through
handle and tighten into shell (see Figure 3).
Make sure rear screw goes through shell and
into fan guard. Tighten screws firmly.
Figure 3 - Removing Screw from Top of
Fan Guard
Flat Side
Facing Up
Slot
Figure 4 - Installing Nut Clip
4
Nut Clip
Remove
Screw
Nut Clip
Shell
www.desatech.com
Figure 5 - Attaching Handle
Screws
Handle
Rear of
Heater
111656-01E