Desa BLP30 Owner's Manual page 3

Propane construction forced air heater
Hide thumbs Also See for BLP30:
Table of Contents

Advertisement

Available languages

Available languages

SAFETY INFORMATION
Continued
14. Minimum heater clearances from combus-
tibles: Outlet: 6 Ft. (1.83 m) Sides: 2 Ft. (0.61 m)
Top: 6 Ft. (1.83 m) Rear: 2 Ft. (0.61 m)
15. Keep heater at least six feet from propane
tank(s). Do not point heater at propane tank(s)
within 20 feet.
16. Keep propane tank(s) below 100° F (37.8° C).
17. Check heater for damage before each use. Do
not use a damaged heater.
18. Check hose before each use of heater. If highly
worn or cut, replace with hose specified by
manufacturer before using heater.
19. Locate heater on stable and level surface if
heater is hot or operating.
20. Not intended for use on finished floors.
21. Never block air inlet (rear) or air outlet (front)
of heater.
22. Keep heater away from strong drafts, water
spray, rain or dripping water.
23. Do not leave heater unattended.
24. Keep children and animals away from
heater.
25. Never move, handle or service a hot, operat-
ing or plugged-in heater. Severe burns may
result. You must wait 15 minutes after turning
heater off.
26. To prevent injury, wear gloves when handling
heater.
27. Never attach duct work to front or rear of
heater.
28. Do not alter heater. Keep heater in its original
state.
29. Do not use heater if altered.
30. Turn off propane supply and unplug heater
when not in use.
31. Use only original replacement parts. This heater
must use design-specific parts. Do not substi-
tute or use generic parts. Improper replacement
parts could cause serious or fatal injuries.
UNPACKING
1. Remove all packing items applied to heater for
shipment. Keep plastic cover caps (attached to
inlet connector and hose/regulator assembly)
for storage.
2. Remove all items from carton.
3. Check all items for shipping damage. If heater
is damaged, promptly inform dealer where you
bought heater.
111656-01E
Hot Air Outlet
(Front)
Piezo
Ignitor
Button
Automatic
Control Valve
Button
Hose/
Regulator
Assembly
Figure 1 - 30,000 Btu/Hr Model Shown
Clean Heated
Air Out (Front)
Combustion
Chamber
Figure 2 - Cross Section Operational View
www.desatech.com
Outer Shell
Handle
Air For Combustion
Hose/Regulator Assembly
Motor
Power
Cord
Fan Motor
Cool
Air In
(Back)
Air For Heating
3

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Nlp30Rem30lpRlp30Rllp35Blp42Rm40lp ... Show all

Table of Contents