Toyota PASEO 1999 Owner's Manual page 70

Anchor bracket
64 mm (2.5 in)
355 mm (14.0 in)
On the filler panel behind the rear seat
a. Using the illustration as a guide, run
your fingers across the trim of the filler
panel itself to locate the position of the
holes underneath.
b. Make a hole in the covering directly
above the hole in the filler panel.
c. Insert a 15 mm (0.6 in.) spacer and
tighten down the anchor bracket for your
child restraint system with a bolt. Torque
the bolt to 16.5—24.7 N⋅m (1.68—2.52
kgf⋅m, 12.2—18.2 ft⋅lbf).
To comply with Canadian Motor Vehicle
Bolt
Safety Standards, this model sold in Can-
ada is provided with a bracket set in the
glove box, designed for use with any of
Spacer
the 2 anchor locations shown in the il-
lustration.
If your child restraint system does not
provide any of the necessary parts, ask
your Toyota dealer. (See "—Child restraint
system".)
'99 MY PASEO (U)
Tilt steering wheel
To change the steering wheel angle,
hold the steering wheel, push down the
lock release lever, tilt the
wheel to the desired angle and return
the lever to its original position.
CAUTION
D
Do not adjust the steering wheel
while the vehicle is moving.
D
After adjusting the steering wheel,
try moving it up and down to make
sure it is locked in position.
steering
63