Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for jcm-tech BASE 30 Series
Summary of Contents for jcm-tech BASE 30 Series
- Page 1 BASE 30 / BASE 500 User Manual...
-
Page 2: Table Of Contents
Table of contents Important safety instructions Use of the equipment Introduction Base30-1/Base30-2 Base500-1/Base500-2 Base500-1B/Base500-2B Installation and connections Operating Programming Manual programming Standard programming Special programming Total reset Groups Group configuration Technical data Regulatory Data EU Declaration of conformity jcmtechnologies... -
Page 3: Important Safety Instructions
Important safety instructions Disconnect the power supply whenever you proceed to the installation or repair of the equipment. In compliance with the European Low Voltage Directive, we inform you of the following requirements: •When the devices remain permanently connected, an easily accessible connecting device must be incorporated into the wiring. •This system must only be installed by qualified professionals that have with automated garage doors and knowledge of the rel- evant European standards. -
Page 4: Introduction
Introduction Base30-1/Base30-2 Base500-1/Base500-2 jcmtechnologies... -
Page 5: Base500-1B/Base500-2B
Base500-1B/Base500-2B Antenna conection Jumper 12/24V Channel 1 operation LED Channel 2 operation LED Programming pushbutton Jumper reset Microswicht Imp/Biestable Power supply Relay 1 output Relay 2 output Memory card connection jcmtechnologies... -
Page 6: Installation And Connections
Installation and connections Attach the rear part of the housing to the wall using the plugs and screws supplied. Pass the cables through the bottom of the receiver. Connect the power cables to the terminals marked in the mother board, as indicated. Fix the receiver front to the rear part using the screws supplied. -
Page 7: Groups
Groups Receivers can be configured with a group (from 0 to 7) so that there is no interference when working near each other. Group configuration The configuration can be carried out with the programming tool or by self-programming as follows. Self-programming: After the receiver has been totally reset, it will be configured with the group of the first radio-programmed transmitter by enabling the hands free mode. -
Page 8: Technical Data
The manufacturer JCM TECHNOLOGIES, S.A. declares that the product BASE30-1, BASE30-2, BASE500-1B, BASE500-2B, BASE500-1, BASE500-2, 2000000, 2000116, 2000122, 2000123, 2000001, 2000734 complies with the relevant fundamental requirements of the RED Directive 2014/53/EU and of the RoHS Directive 2011/65/EU. See website https://www.jcm-tech.com/declarations/ JCM TECHNOLOGIES, SA C/COSTA D'EN PARATGE, 6B 08500 VIC (BARCELONA)