K-Tech ET401 Quick Programming Manual

Quick Troubleshooting
Line Specifications:
The K-Tech ET401 is a single line,
phone line powered phones that works
on most phone lines meeting the follow-
ing minimum conditions:
1. 24—48 V Analog line (on hook)
2. DTMF compatible
3. 30 mA min loop current
4. 18 –22 gauge shielded twisted pair
in elevator traveling cable.
Phone number hints:
Check to see if you need to dial the
area code or 1 before the number.
On PBX systems you may have to put a
9 or 8 and a pause (*) before the phone
number. Also you may need to set the
timer to "02" or "03" for proper shutoff.
Special Conditions:
If using the K-Tech ET401 with an ex-
ternal dialer or ringdown circuit, please
call for more information.
ET MODEL IDENTIFICATION
ET401A—Box Mount
Sentry
ET401A-LPSS—Low Profile
Liberator
ET1401A—Flush Mount
Fortress
ET401A-OEM—COP mount
Commander
The information below is important.
You must have the Serial Number
available when calling Tech Support.
K-Tech International Inc. SERIAL #
4 _ _ _ _ _
Part # PCB017 Rev. ___
Serial Number: ____________________________
Date Installed: ____________________________
Installed by: ____________________________
Phone Line #: ____________________________
Phone line Voltage: 48VDC (POTS or CO line)
24VDC (PBX System)
Other ____________________
Phone Number(s)
Dialing:
1. ___________________________________
2. ___________________________________
3. ___________________________________
4. ___________________________________
5. ___________________________________
Voice message
________________________________________________
________________________________________________
________________________________________________
________________________________________________
K-Tech International Inc.
•
PO Box 1025 56 Ella Grasso Ave
Torrington, CT 06790 USA
Phone: 1-800-993-9399
Phone (860) 489-9399
Fax (860) 489-4399
Email: support@KTechOnline.com
BOK036 rev. 020703 Printed in USA
K-Tech
For programming
using the built-in
+
keypad
LED
-
12 - 30V
LINE SWITCH
ONLINE
PROG
Remote LED
+
2V 7mA
Remote Button
Dry
Contacts
R
Telephone Line
T
Connect telephone line
RINGS
2 -
shield to true earth ground
5 -
7 -
at one end only!
ET401
Quick
Programming
Guide
KEEP THIS BOOKLET
WITH PHONE
For more detail refer to the
installation manual.
Battery
(9.0 VDC)
(2 VDC @ 7 mA)
(N.O. Contacts)