Download Print this page

Saft MRX Series Installation And Operation Instructions page 2

Ni-cd batteries

Advertisement

MRX Ni-Cd batteries
5.2. Discharged block battery
stored more than 1 year:
a) charge at 0.2
C
A
for 10 h
5
b) discharge at 0.2
C
A
down to
5
1.0 V/cell
Between discharge and the
following charge, the battery must
be kept in open circuit for
8 hours or battery temperature
down to ≤ +30°C (≤+86°F).
c) charge at 0.2
C
A
for 8 h
5
The battery is ready for use.
5.3. Charged block-battery (80%)
shipped and stored at temperatures
below +30°C (+86°F), less than
3 months from date of charge:
the battery is ready for use.
5.4. Charged block-battery (80%)
shipped and stored at temperatures
above +30°C (+86°F) or stored more
than 3 months from date of charge:
a) charge at 0.2
C
A
for 10 h
5
C
A
b) discharge at 0.2
down to
5
1.0 V/cell
c) charge at 0.2
C
A
for 8 h
5
The battery is ready for use.
6. Charging in service
On-board application (railway)
I
The battery is cycled up to 20%
Depth Of Discharge (DOD) per day.
Single level charge:
1.45 to 1.55 V/cell at +20°C (+68°F)
1.47 V/cell is recommended
I
Stationary application
The battery is on float and discharged
only in case of emergency.
Single level charge:
1.41 to 1.43 V/cell at +20°C (+68°F)
Dual level charge:
- High level: 1.43 to 1.50 V/cell
at +20°C (+68°F)
- Float level: 1.38 to 1.40 V/cell
at +20°C (+68°F)
Voltage compensation
I
For use at temperature range
outside +10°C to +30°C (+50°F
Saft
Industrial Battery Group
12, rue Sadi Carnot
93170 Bagnolet - France
Tel: +33 1 49 93 19 18
Fax: +33 1 49 93 19 64
www.saftbatteries.com
to +86°F), the charge voltage
correcting factor is:
– 3 mV/°C/cell (– 1.7 mV/°F/cell)
if the charging voltage is ≥ 1.45 V
at +20°C (+68°F)
For any other charging voltages,
consult Saft.
To minimise the water
consumption, Saft recommends
the use of low charging voltage.
7. Topping-up
Before topping up operation, the
water filling circuit of the battery
must be checked for tightness (no
leaks) using a pressure test (a kit
may be supplied by SAFT).
Use only distilled and deionized
water for topping-up.
Connect distilled water tank to the
self-closing inlet.
Topping-up is completed when an
excess of 1 litre of water is measured
at the outlet of the water filling circuit.
Topping-up can be performed by
Saft's gravity kit or by using Saft's
water filling stations.
8. Periodic maintenance
In addition to the topping-up,
a periodic maintenance shall be
carried out at least every 5 years.
For detailed maintenance, please
refer to the maintenance manual of
the battery.
I
Keep the battery clean using only
water. Do not use a wire brush or
solvents of any kind.
I
Check torque of all terminal
screws. Coat with grease approved
by Saft or neutral vaseline all
terminal screws and connections.
I
Check charger settings. It is very
important that the recommended
charging voltage remains
unchanged. High water
consumption by the battery is
usually caused by improper voltage
setting of the charger.
Doc N° 21119-2-1010
Data in this document is subject to change without
notice and becomes contractual only after written
confirmation.
Société anonyme au capital de 31 944 000 €
RCS Bobigny B 383 703 873
Pragma - Printed in France - 2k
Table A:
Rated
Charge
Cell type
capacity
current
Ah
MRX 70
70
MRX 80
80
MRX 90
90
MRX 100
100
MRX 115
115
MRX 130
130
MRX 145
145
MRX 160
160
MRX 180
180
MRX 200
200
MRX 230
230
MRX 260
260
MRX 280
280
MRX 300
300
MRX 350
350
MRX 400
400
MRX 460
460
MRX 520
520
I
Frequency of topping-up must be
determined for each battery.
Topping-up shall be performed
every 6 months during the first
year in order to determine the
ideal topping-up interval (generally
every 2 years). It depends on the
charging voltage and actual use of
the battery. Refer to section 7
concerning topping-up.
9. No change of electrolyte
required
Thanks to the sintered/plastic
bonded electrode technology, it is not
necessary to change the electrolyte
during the life of the battery.
10. Recycling
To protect the environment, all used
batteries must be recycled. Contact
your local Saft representative for
information.
Amp
14
16
18
20
23
26
29
32
36
40
46
52
56
60
70
80
92
104

Advertisement

loading

This manual is also suitable for:

Mrx 70Mrx 80Mrx 90Mrx 100Mrx 115Mrx 130 ... Show all