Makita GA5010 Technical Information page 7

R
epair
[3] -3. Shaft lock section
DISASSEMBLING
1) Remove Bearing box from Gear housing. (Fig. 9 on page 4)
2) Shoulder pin 5 can be removed from Gear housing using 1R268, 1R350 and plastic hammer as illustrated in Fig. 20.
Fig. 20
Gear housing
ASSEMBLING
Do the reverse of the disassembling steps.
Note: Do not reinstall removed Pin cap because removal of Shoulder pin 5 damages the inside surface of Pin cap.
Be sure to remove plastic dust of Pin cap from Shoulder pin 5 and to install it onto new Pin cap.
1R268
Pin cap
1R350
Gear housing
P 7 / 9
1R268
Pin cap
Compression spring 8
Shoulder pin 5
O ring 7
1R350