Temptime EDGE Medication Monitor Quick Start Manual

QUICK START GUIDE: Instructions for Use
EDGE Medication Monitor and EDGEVue App
The EDGE Medication Monitor is a sensor that continuously measures the temperature of your medication and communicates with
your Smart Phone or other mobile device. This gives you peace of mind about your valuable medication by alerting you, when you
check it, if it has exceeded the temperature range as indicated by the manufacturer.
For help with setup or technical questions about the EDGE Medication Monitor, call 1-888-686-EDGE (3343) or email at
EDGESensors@temptimecorp.com
Contents of the EDGE Medication Monitor (MM-1)
•
1 x M-300 Sensor Module (30-M300-2)
•
1 x LS14250 Lithium battery
•
1 x Magnet (for mounting or checking LED)

Install Battery

1. Insert battery (included). Be sure to match the + / - polarity
as shown in (Image #1).
2. Place on rear cover and secure with screws provided (Image #2)
3. Place EDGE sensor in the refrigerator next to your medications
for 30 minutes before setting temperature high/low limits on Page 2.

Install EDGEVue App

Download EDGEVue Mobile App by either:
a) Scanning the QR Code on back of device/packaging, or
b) Download from iTunes App Store or GooglePlay, search for EDGEVue.
Setup Temperature High/Low Limits for
Your Medication
1. Open the EDGEVue App on your smart phone
2. Tap on Scan (Image #3)
3. When the Sensor serial number appears, tap on it to pair the Sensor
and the App (Image #4)
NOTE: If at any point you lose Bluetooth connection to the EDGE device, go
back to the Scan screen, tap the refresh button
tap on it.
COMZ EDGE Medication Monitor Quick Start Guide
•
•
, find your sensor and
1 x set of 3 screws
1 x Instructions for Use
Image 1
Image 3
Image 2
Image 4
1
Rev 3