Niko 550-00003 Manual page 20

On the controller are three LEDS providing more information on the controller and the installation:
LED Status
STATUS LED The green
LED lights up
continuously
The green LED
flashes
The orange
LED lights up
continuously
The red LED
lights up
continuously
The LED is
not on
PROGRAM The green
LED LED lights up
continuously
SERVER LED The green
LED lights up
continuously
The orange
LED lights up
continuously
The red LED
lights up
continuously
20
Connected controller
Information
The installation functions normally.
The installation is initializing or is currently
being updated.
A problem has been detected.
A serious problem has been detected.
The controller does not receive power
supply voltage or is defective.
The controller is in manual program mode In an installation programmed with
The connection with the Niko server is
working properly and the installation was
registered correctly.
The connection with the Niko server is
working properly but the installation was
not yet registered.
No communication possible with the
Niko server. The internet connection
was interrupted or the Niko server is not
accessible.
Possible causes and actions
/
After approximately one minute, the
status ends automatically. Under no
circumstances should the installation be
switched off.
Consult the diagnostics page in the
programming software for more
information (see Using the diagnostics
page on page 21).
Consult the diagnostics page in the
programming software for more
information (see Using the diagnostics
page on page 21).
Check if the TEST mode is active.
Measure the power supply voltage. If
the problem persists, contact the Niko
customer service.
programming software 2.0, this LED has
no function
/
Use the information of the controller
(MAC address and serial number SN
found on the controller and the included
label) to register the installation on
https://mynikohomecontrol.niko.eu.
Please check the internet connection.
If the internet connection is working
properly, contact the Niko customer
service.