Table of Contents
Advertisement
plus or minus button on the side of the monitor to scroll
through the tire sensors� Slide the switch on the right
side of the display up to turn the display on and down
to shut it off� If the display is plugged into a constant
12v source, you must unplug the display to turn it off�
NOTE
Indoor/outdoor thermometers could interfere with
the signal of the sensors.
Power Stabilizing Jacks
The Classic trailer is equipped with two sets of power
stabilizing jacks� These jacks are controlled by a switch
located in the locked utility compartment on the side of
the trailer�
NOTE
Power stabilizing jacks automatically adjust to the
terrain and should only be lowered until they make
contact with the ground.
CAUTION
Stabilizing jacks are designed to stabilize the
trailer only. Misuse of the power jacks to level or
lift the trailer will result in damage to the jacks and
potentially the trailer.
Power Jack
A switch located on the bottom of the housing operates
the power jack� When the jack is fully extended or
retracted, internal limit switches automatically shut off
the motor�
The jack is wired directly to the battery and has a
spade fuse between the battery and the power head�
Refer to Section 8 - Maintenance for fuse information�
• Use the jack for lifting the trailer only�
• Never get beneath the travel trailer when only the
power jack supports it�
• Support the vehicle by appropriate means�
Avoid the risk of injury to yourself and others.
Keep hands and feet from under the foot plate
when using the jack. Do not use or install dolly
wheels on the power jack. Failure to comply could
result in serious injury
2020 Classic
WARNING
Power Jack Fuse
Should an electrical failure occur, first check to see if
the fuse, located in the battery box, has blown� If the
fuse is not blown and the jack still will not operate you
can manually operate the jack by placing the manual
override handle into the alignment tube and engaging
the drive pin� Rotating the handle counterclockwise
to raise or clockwise to lower the trailer� If the fuse is
blown, replace the fuse with the same type and check
to see if the jack is now operable�
Refer to the Maintenance section for replacement and
maintenance of the power jack�
Liquid Petroleum Gas (LPG)
Fill Valve
The LPG tanks are equipped with fill valve connections
RV Type I Acme� The large, green, nylon swivel nut is
a right-hand thread and is designed for hand operation
only�
The valve features an internal spring-loaded module
that will not allow gas to flow from the cylinder until a
positive seal has been made at the connection� The
valve outlet has 1-5/16 in� Acme threads on the outlet
exterior, and female POL fitting; left-handed threads
on its interior� This feature allows for connection of the
new, wrench less, right-handed, Acme RV connection
while still accommodating the standard left-handed
POL fittings used for filling propane cylinders.
Exterior
6-7
Advertisement
Chapters
Table of Contents
