Table of Contents
Advertisement
GWM Installation manual
Mounting the chain coupling
The gearbox is normally coupled to the load by chain coupling to the drive shaft. See the details below for
maximum torque and maximum alignment error.
Type of chain coupling
10B Z16 (5/8" x 3/8")
Warning
1. Mount the chain sprockets of the coupling on the output shaft and the drive tube;
2. Turn the chain sprockets of the coupling until the teeth are aligned;
3. Wrap the dual chain around the teeth of the sprockets, the ends of the chain should be on top of the
coupling;
4. Fit the chain as shown in the diagram below.
De Gier B.V., Westlandseweg 9, 2291 PG WATERINGEN, THE NETHERLANDS, Tel. +31 (0)174 292089, Fax +31 (0)174 295644.
Max. torque [Nm]
420
Do not exceed the maximum rated torque of
•
chain couplings and accessories.
•
The load must be distributed evenly over both
ends of the shaft. Preferably fit the drive unit in
the middle of the drive train.
The maximum angle a chain coupling is allowed
•
to make must remain below the specified value.
Max. angle
4°
Page
13
Advertisement
Table of Contents
