babymoov High Care A014001 Instructions For Use Manual page 17

• To ckeck your settings, press briefly on the receiver mode button (3). The various settings will be displayed
according to a cycle :
EOut of range
larm condition
• The night light (4) can be set permanently ON by moving the power ON/OFF switch to position . The night
light can also be set to be VOX (voice activated) by momentarily pressing the mode button (3) : the VOX
icon will be shown besides the icon . Under VOX mode, the night light will be switched on once the
microphone 5 detects a sound and automatically goes off a few seconds after the microphone 5 stops
picking up any sound.
• The condition of the battery is shown by the battery status indicator
consumed, the segments within the battery status indicator gradually falls. Once the indicator becomes
empty it will start flashing, besides, the transmitter will also send out a signal to the receiver to alert
the parents.
B / Receiver
• Place the receiver at a reasonable distance away from the transmitter to avoid feedback. Too close a distance
will create a screeching sound.
• Once the unit receives a signal from the transmitter, the screen will become backlighted and LEDs in the
level meter will light up. The louder the baby's voice, the more number of LED will be lighted up.
• The speaker volume can be adjusted using the Up/Down button (9). The volume bar graph in the screen
will also change correspondingly. More segment of bar graph shown means higher volume from speaker.
When no segment is shown on the screen, the speaker is totally muted.
• This unit is equipped with a vibrating alert. Set the power ON/OFF switch (8) to position
icon will also show up in the LCD. Once the received baby's voice is loud enough, the vibrator starts
functioning. To save battery power, it is recommended not to use the vibrating alert frequently.
• When the out-of-range alert function is set to On in both transmitter and receiver, once the receiver is beyond
the communication range of the transmitter for over 2 minutes, an out-of-range alarm will be heard. The
LED level meter starts flashing together with the out-of-range icon
temperature reading will show - -°C . The alarm and icon will go off only when the receiver falls back within
the communication range of transmitter.
N.B.: This alarm will also be heard in case the transmitter is switched off, or its battery has run down, or
its power is cut off, or the channel/digital code setting is different between the transmitter and receiver,
or the out-of-range alert setting is different between transmitter and receiver.
• Whenever the baby's room temperature falls outside the range as preset by the upper and lower
temperature limits, an alarm will be heard : the correspondingly icon (U ou L) and the current temperature
reading start flashing in the screen.
• To check your settings, press briefly on the receiver mode button (10). The various settings will be displayed
according to a cycle:
Lower temperature limit
Upper temperature limit
18
BABYPHONE HIGH CARE • Instruction Manual
Current baby's room
temperature
Selected channel
and digital code
Selected
output power
. When the battery power is being
to alert the parents. Besides, the
Current baby's room
temperature
Selected channel
and digital code
Out of range alarm condition
. The vibration