Primer Button - BOMBARDIER Ski-Doo MX Z X 440 2004 Operator's Manual

High Speed Compression Adjuster
The High speed adjuster modifies the damping force for high suspen-
sion velocities — more than 0.5 m/s (1.6 ft/s). It tunes the vehicle for
hoops or bumps that create high speed movement in the suspension.
This adjuster has 3 turns of adjustment. Use a 17 mm wrench to
adjust it. Turning it clockwise increases shock damping action (stiffer)
for these high compression speeds.
1 2
A33F0DA
1. Low speed compression adjuster (flat screwdriver)
2. High speed compression adjuster (17 mm wrench)
Center and Front Springs
CAUTION: Make sure that center spring and both front springs
are still preloaded when front of vehicle is off the ground. Maxi-
mum spring preload is 25 mm (1 in). Otherwise, spring will be
coil bound when fully compressed.

61) Primer Button

Pull and push button. It is not necessary when engine is warm.
To prime, activate button until a pumping resistance is felt. From this
point, pump 2 or 3 times to inject fuel in intake manifold. After prim-
ing, ensure that primer button is pushed back.
NOTE: In very cold temperature, it is recommended to rotate primer
button 3-4 turns prior to pull it. This will eliminate the possibility of
sticking.
5