Page 1
2320 P S I Electric Pressure Washer ASSEMBLY, CARE AND USE INSTRUCTIONS Model SP160RLW READ CAREFULLY IMPORTANT: RETAIN THESE INSTRUCTIONS ATTACH RECEIPT TO MANUAL FOR FUTURE REFERENCE Questions, problems, missing parts? Before returning to your retailer, contact our customer service department, 8:30 am - 5:00 pm, Monday - Friday.
SAFETY INFORMATION SAFETY INFORMATION SAFETY INFORMATION Please read and understand this entire manual before power tool carefully and only when you are alert. attempting to assemble, operate, or install the product. 10. Watch your balance and footing while using your pressure washer.
Page 5
34. NEVER use lances or other parts that are not will overheat and damage the high pressure pump. compatible for this specific SP Jetwash unit. 26. NEVER leave the pressure washer unattended while 35. NEVER spray any electrical outlet with your pressure it is powered “ON”.
PREPARATION PREPARATION PREPARATION Before beginning assembly of product, make sure all Tools Required for Assembly (not included): Phillips parts are present. Compare parts with package contents screwdriver. list and hardware contents list. If any part is missing or damaged, DO NOT attempt to assemble the product. Estimated Assembly Time: 5 minutes ASSEMBLY INSTRUCTIONS Power Unit Assembly...
Page 7
ASSEMBLY INSTRUCTIONS Slip tab of stabiliser foot (M) into slot on bottom right High Pressure Hose Assembly of the pressure washer. Secure stabiliser foot (M) to Connect the other end of high pressure hose (B) to pressure washer (A) using screw provided (AA) spray gun (F) by screwing collar over gun inlet.
Page 8
ASSEMBLY INSTRUCTIONS Lock Unlock Variable Spray Locking Spray Gun (before lance installation) Nozzle Lance and Turbo Nozzle To lock the trigger of the spray gun, (I), aim the gun Lance Installation away from you and push the lock button from right to While the spray gun (F) is in the locked position, insert left.
Page 9
ASSEMBLY INSTRUCTIONS ASSEMBLY INSTRUCTIONS Attach the extension lance to the angle connector Patio Cleaner Installation The patio cleaner (K) is specially designed for cleaning and then attach the extension lance to the brass large flat surfaces. adaptor and then attach the spray gun (F) to the Attach the adaptor to the patio cleaner (K) housing.
Page 10
OPERATING INSTRUCTIONS ASSEMBLY INSTRUCTIONS Garden Hose Adapter Installation Remove plastic shipping cover on water inlet, front You will need a quick connect hose adapter (not right side when facing the unit (A). Install the supplied) fitted to the end of your garden hose (N). transparent water filter (J) by hand tightening clockwise.
OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS • Turn the tap on fully to ensure good water supply. • Make sure the “ON/OFF” switch is in the “OFF” position. The power switch has international symbols for ‘on’ and ‘off’: On (|) Off (O). •...
Page 12
OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS • When using the detergent, fill it with a properly The pressure washer will pull a ratio of water to formulated detergent or cleaner with water ratio detergent of 10:1 or 10 parts water to 1 part detergent. according to instructions on the container.
Page 13
CARE AND MAINTENANCE OPERATING INSTRUCTIONS Operation Tips • If you hear the motor run intermittently when the trigger is not being squeezed, that is normal. The pump is priming itself so it is ready to operate when the trigger is squeezed. Turn off the pressure washer if not being used after five minutes.
OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS CARE AND MAINTENANCE Detergents Cleaning Nozzles • Use detergents designed for pressure washers. • A clogged or partially clogged nozzle can cause • This system applies detergent under low pressure. significant reduction of water pressure coming out The cleaning power of the detergents is enhanced of the nozzle and/or cause the unit to pulsate while when applied with low pressure and enough time is...
OPERATING INSTRUCTIONS TROUBLESHOOTING PROBLEM CORRECTIVE ACTION Unit will not turn on. 1. Check the power cord is plugged directly into an outlet. 2. Do not use an extension cord. 3. Make sure the power switch is turned on. Note: When pressure switch is turned on, the pressure washer will turn on by itself for 1-2 seconds and shut off.
* AR & SP are brand names of products distributed by Austech Industries Note # Units which are failing to perform in accordance with specifications due to non-warrantable causes will be subject to freight, repair and or quote charges.
Need help?
Do you have a question about the JETWASH SP160RLW and is the answer not in the manual?
Questions and answers