Advertisement
Focal Adjustment:
Power on the fixture and remove the barrel by unscrewing it from the middle of the fixture. Be sure to
never look directly at the LED while the fixture is on.
Now, move the primary optic as close to the LED as possible and the secondary optic as far from the LED
as possible on the optic slider rails. You may need to loosen the set screws on the primary and
secondary optics in order to slide them along the rails.
Primary Optic
Secondary Optic
Slowly begin sliding the secondary optic toward the LED until the projected image comes into focus. This
will be the narrowest focused beam the fixture can achieve.
This picture shows the fixture in its narrowest beam configuration
Advertisement
