Leak Testing Valve, Hose And Regulator; Lighting The Hob; Lighting The Oven - Kampa Roast Master Instructions Manual

Double gas hob & oven
Hide thumbs Also See for Roast Master:
Table of Contents

Advertisement

or kinked.
· Also be sure that the hose is not too close to heat sources, especially with
the rear of the oven.

Leak Testing Valve, Hose and Regulator

1. Turn all control knob(s) to OFF
2. Be sure regulator is correctly connected to the gas cylinder (see
manufacturer s instructions).
3. Completely open regulator valve (see manufacturer s instructions). If you
hear a hissing sound, turn gas off immediately. There is a major leak at
the connection. Correct before proceeding.
4. Brush soapy solution onto indicated connections shown below.
5. If growing bubbles appear, there is a leak. Turn off the gas supply in event
of gas leak. If leaks cannot be stopped, do not try to repair. Consult a
qualified technician.
6. Always close regulator valve after performing cylinder leak test.
7. Before each use, check to see if hose is damaged, cut or worn. Replace
damaged hose assembly before using appliance. Use only gas
cylinder/hose/regulator specified by the manufacturer or seller.
WARNING:
· Never use a match or lighted flame to search for leaks
· Do not use appliance until leak checked
· If you cannot stop a gas leak, immediately close regulator valve and call
gas supplier or your fire department.

Lighting the Hob

1. Do not lean over the appliance while lighting.
2. Remove all cookware from the stove to create a free flow of air.
3. Open top lid. Do not attempt to light the stove with lid closed.
4. Fully open regulator valve.
5. Turn control knob slowly to the High position. The burner will ignite.
Adjust controls to desired temperature. The left hand control knob
operates the left hand burner. The right hand control knob operates
the right hand burner.
6. If the burner does not stay lit, repeat the process.
7. If ignition does not occur in 5 seconds, turn the burner control(s) off,
wait 5 minutes, and repeat lighting procedure. If built-in ignition will not
light follow instructions for lighting with a match.

Lighting the Oven

The oven is fitted with a flame failure device (FFD).
accidentally goes out, then the supply of gas will be cut off.
5
If the oven burner

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents