Setup Instructions; Connect The Gas To The Stove/Oven - Kampa Roast Master Instructions Manual

Double gas hob & oven
Hide thumbs Also See for Roast Master:
Table of Contents

Advertisement

· · The wire pan stand
· · Oven shelf
· · Oven spill tray
Note:
1. The wire pan stand sits on the burners.
2. The oven shelves are fitted into the oven.
3. The oven spill tray is inside at the bottom of oven (it forms the oven floor).

Setup Instructions:

· Remove all packaging.
· Setup the oven on a level, non-combustible surface.
· Open the lid and attach the windscreens to the side of the oven as shown.
· Make sure the pan stand is installed properly with the wire ends fitting into
the holes on the top of the oven to prevent the stand from moving (see
picture)

Connect the Gas to the Stove/Oven

Notice:
1. A low gas pressure regulator is necessary for operation, use the
regulator recommended by the manufacturer or seller.
supplier will be able to offer you more advice.
2. Before you assemble the regulator, please check the gas type and
pressure shown on the gas cylinder, and make sure the information on
the regulator and cylinder match
3. A hose to connect the appliance to the gas regulator and cylinder is
required, and the maximum length should not exceed 1.5m. The hose
should comply with BS3212/2.
4. The connecting hose should not be twisted or constricted. The hose
should be checked each time the appliance is used and each time the
gas cylinder is changed. If it shows signs of cracking, splitting or other
deterioration it should be renewed with a hose meeting the same quality
standards (BS3212/2).
5. Change the connecting hose within the national requirements.
Connect:
· Be sure that the burner & oven valves are in the OFF position before you
connect the stove to a gas supply.
· Attach the gas hose (not supplied) to the stove inlet. You will find it
easier to fit by applying soapy water to the gas inlet before pushing the
hose on. Secure using a suitable hose clamp. Attach the other end to
your low pressure regulator (not supplied) using the same method and
secure using clamp.
· Be sure that the hose is fitted correctly and is not being stretched, twisted
1pc
2pcs
1pc
4
Your gas

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents