Advertisement
How to replace a bushing or drive gear
During the life of your Alliance machine it may be necessary to
replace a bushing or drive gear within the mixing shelf.
To do so:
1. Turn off the power to your Alliance mixing machine.
2. Remove the expanding bolt and shaft(s) necessary to access
the bushing or drive gear that needs to be replaced. It is
unnecessary to remove the belt.
(See How to repair the machine without disassembling it.)
3. The drive gear can be removed by squeezing the bottom of
the gear together and lifting it straight up out of the bushing.
4. Once the drive gear is removed, the bushing can be removed
by loosening the two screws used to secure it.
5. To replace the bushing, install the new bushing from the
bottom of the shelf and screw it in from the top.
6. To replace the drive gear, gently press it into the bushing until
it snaps into place. The bottom lip of the drive gear should
snap and secure it in place against the bottom of the bushing.
Note: It is good practice to check that all of the other drive gears
are snapped into place and seated correctly before replacing all
of the shafts. The drive gears may become dislodged while
moving the shafts.
How to lubricate your Alliance machine
Periodic lubrication to the three pulley shoulder bolts
under each mixing shelf will help maintain quiet
operation of the machine. A small drop of lubricant
under the head of the shoulder bolt should be all that is
required. Make sure the shoulder bolt is free of dirt
before lubricating. We suggest using Spray Gun Lube or a
lubricant that your paint manufacturer recommends.
The lubricant must be Silicone free.
Note: In extremely dirty environments is may be
necessary to remove the shoulder bolt from the pulley
assembly and clean off the dirt before lubricating.
Bushing
PN# 5278E-M
Upper Shaft
Drive Gear
Mix Shelf
Bushing
Drive Gear (Lip)
Lower Shaft
Drive Gear
PN# 5931
Lubricate here
Shoulder Bolt
PN# 5364
Pulley
PN# 5930
Washer
PN# 5804S
Locknut
PN# P0025
Advertisement
