Advertisement
3. CONTROLS
FRONT PANEL LAYOUT
3.1
1. WELDING CURRENT CONTROL
2. WELDING MODE SWITCH
3. GREEN LED:
4. TIG START MODE SWITCH:
5. DUAL FUNCTION CONTROL:
‘current slope down time’
6. DINSE SOCKET
7. DINSE SOCKET
8. GAS PIPE FITTING
9. CONNECTOR SOCKET
10. FAULT INDICATOR
Thermal protection:
Mains over/under voltage protection:
Short circuit protection:
REAR PANEL LAYOUT
3.2
11. MAIN ON/OFF SWITCH
12. MAINS CABLE
13. GAS INLET FITTING
14. REMOTE CONTROL CONNECTOR.
Pedal Remote control (Model No. INV/TIG/5)
Remote Control with two potentiometers (Model No. INV/TIG/7)
(Model No. INV/TIG/7)
Remote Control with
two potentiometers
4.
PREPARING INVERTER FOR USE
CONNECTION TO THE MAINS:
however the unit is used consistently at high output, connection to a 30amp supply may be considered. Seek the advice of a qualified electrician
on connection to a suitable supply.
WELDING CABLE CONNECTIONS.
Fig 4
(refer to Figure 2).
‘HF’
‘LIFT’
+
-
(refer to Figure 3).
optional
The unit is fitted with a 13amp plug and is designed to operate in both welding modes on a 13amp supply. If
fig 2
‘arc force’
fig 3
(Model No. INV/TIG/5)
Pedal Remote control
Fig 5
Advertisement
