Advertisement
Operating instructions
Read the EntiRE iMpORtAnt SAFEty inFORMAtiOn section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
tool Set Up
Battery charging
Charge battery before using this tool. Follow instructions included with battery charger (sold separately).
Operating instructions
choose power Supply
1. Battery pack: Insert fully charged Battery
Pack into back of Work Light, making
sure it clicks into place securely.
Work Light placement
cAUtiOn! Keep Work Light and cord out of walkways.
1. Freestanding: Place Work Light on a flat surface.
2. Hook:
a. Select a suitable location for hanging the Work
Light. The Work Light must be hung from
a sturdy mounting location able to support
the weight of the Work Light and Battery.
b. Lift Hook from slot and hang
carefully in selected location.
3. Wall Mount:
WARninG! Verify that installation surface has no
hidden utility lines before drilling or driving screws.
WARninG! Do not install the
Work Light directly into drywall.
a. Select a suitable location for
hanging the Work Light.
b. Choose two adjacent studs. If drywall
is present, use a stud finder (sold
separately) and mark locations of studs.
Operation
1. Press Power Button once for "high" light
output. Press again for "low" light output.
Press a third time to turn light off.
Item 56527
For technical questions, please call 1-888-866-5797.
2. 120VAc Extension cord:
a. Remove Battery Pack from Work Light.
b. Connect the extension cord to the
120VAC Input on back of Work Light.
c. Plug the other end of the extension cord
into a grounded 120VAC outlet.
c. Install a 2x4 across the studs.
d. Measure the distance between the
keyholes on the Work Light and mark
mounting locations on the 2x4.
e. Drill holes into the mounting locations,
then drive screws into holes, leaving
1/4" of threads exposed.
f. Place large openings on keyholes
over screws. Pull down gently to lock
screws into upper parts of keyholes.
Keyholes
note: For other types of walls, use appropriate
hardware.
4. Loosen Adjustment Knob, rotate Work Light to
desired position, then tighten Adjustment Knob.
2. After use, remove Work Light from wood studs or
Hook. Ungplug or remove Battery Pack. Clean,
then store the tool indoors out of children's reach.
Page 9
Advertisement
