Advertisement
USER-MAintEnAncE inStRUctiOnS
procedures not specifically explained in this manual must
be performed only by a qualified technician.
tO pREVEnt SERiOUS inJURy FROM AcciDEntAL OpERAtiOn:
Make sure that the Switch is in the off-position and unplug the tool from its electrical
outlet remove its Battery pack before performing any procedure in this section.
cleaning, Maintenance, and Lubrication
1. BEFORE EAcH USE, inspect the general
condition of the tool. Check for:
• leaking, swollen, or cracked battery pack,
• loose hardware,
• misalignment or binding of moving parts,
• damaged cord/electrical wiring,
• cracked or broken parts, and
• any other condition that may
affect its safe operation.
troubleshooting
problem
Flashlight will
1. Cord not connected.
not turn on.
2. No power at outlet.
3. Tool's thermal reset breaker
4. Battery Pack not properly
5. Battery Pack not properly
6. Battery Pack burnt-out.
Follow all safety precautions whenever diagnosing or servicing the tool.
Disconnect Battery pack and charger power supply before service.
Record product's Serial number Here:
note: if product has no serial number, record month and year of purchase instead.
note: Some parts are listed and shown for illustration purposes only,
and are not available individually as replacement parts.
Page 10
possible causes
tripped (if equipped).
connected.
charged.
For technical questions, please call 1-888-866-5797.
2. AFtER USE, wipe external surfaces
of the tool with clean cloth.
3. Li-Ion BATTERY MUST BE RECYCLED OR
DISPOSED OF PROPERLY.
Do not short, incinerate or open battery.
4. Disconnect battery pack and store battery pack,
charger, and tool in dry, indoor area out of
reach of children and away from metal objects
(i.e., paperclips, coins) to prevent shorting.
Likely Solutions
1. Check that cord is plugged in.
2. Check power at outlet. If outlet is unpowered,
turn off tool and check circuit breaker.
If breaker is tripped, make sure circuit is right
capacity for tool and circuit has no other loads.
3. Turn off tool and allow to cool.
Press reset button on tool.
4. Remove Battery Pack, make sure there
are no obstructions, reinsert the Battery
Pack according to its shape (it should
only fit one way), and press firmly until
the Battery Pack locks in place.
5. Make sure Charger is connected and
operating properly. Give enough time
for Battery Pack to recharge properly.
6. Dispose of old Battery Pack
properly or recycle. Replace Battery Pack.
Item 56527
Advertisement
