LG VX11000 Service Manual page 32

VX11000
1.2.5 Dual RX RF SAW FILTER(F1004)
The main function of RX RF SAW filter is to attenuate mobile phone spurious frequency, attenuate noise amplified
by the LNA and suppress second harmonic originating in the LNA.
1.2.6 RTR6500 - Down-converter Mixers part (U1009)
The RTR6500 device performs signal down-conversion for Cellular, PCS and GPS tri-band applications. It contains
all the circuitry (with the exception of external filters) needed to support conversion of received RF signals to Base-
band signals. The three down-converting Mixers (Cellular, PCS and GPS), and a programmable PLL for generating
RX LO frequency and an RX LO Buffer Amplifier and RX Voltage Controlled Oscillator. The GPS LNA & mixers
offer the most advanced and integrated CDMA RX solution designed to meet cascaded Noise Figure (NF) and Third-
order Intercept Point (IIP3) requirements of IS-98D and J-STD-018 specifications for Sensitivity, Two-Tone Inter-
modulation, and Single-tone Desensitization.
Operation modes and band selection are specially controlled from the Mobile Station Modem MSM7500A.
The specification of VX11000 Mixers is described below:
Parameter
Noise Figure
Input IP3
Input IP2
1.3 Description of Transmit Part Circuit
1.3.1 RTR6500 (U1009)
The RTR6500 Base-band to RF Transmit Processor performs all TX signal-processing functions required between
digital Base-band and the Power Amplifier Modulator (PAM). The Base-band quadrate signals are up-converted to
the Cellular or PCS frequency bands and amplified to provide signal drive capability to the PAM. The RTR6500
includes mixers for up-converting analog Base-band to RF, a programmable PLL for generating TX LO frequency a
TX LO Buffer Amplifier and TX Voltage Controlled Oscillator, cellular and PCS driver amplifiers and TX power
control through an 85 dB VGA. As added benefit, the single sideband up-conversion eliminates the need for a band
pass filter normally required between the up-converter and driver amplifier.
I, I/, Q and Q/ signals proceed from the MSM7500A to RTR6500 are analog signal. In CDMA mode, These signals
are modulated by Offset Quadrature Phase Shift King (OQPSK). I and Q are 90 deg. out of phase, and I and I/ are
180 deg. The mixers in RTR6500 converts baseband signals into RF signals. After passing through the up converters,
RF signal is inputted into the Power AMP.
LG Electronics Inc.
Low gain
Cellular PCS
27 27
-5 -11
30 30
High gain
Cellular PCS
10 10
4 1
50 50
Units
dB
dBm
dBm
- 31/143-