Crosley XUF14 Owner's Manual And Installation Instructions page 10

Care and Cleaning
To Remove the Freezer Door
1 . Remove the plastic hinge cover by removing one
screw, disconnect the wiring connector and remove
the ambient thermistor from the hinge cover, and then
lifting it off .
2 . Remove the screws holding the hinge to the top of the
cabinet using a Phillips screwdriver or 5/16" socket
driver . Be carefully not to damage the wiring nearby .
3 . Remove the top hinge from the cabinet and lift the
door up and off the lower hinge pin . Set the door
aside .
4 . Remove the screws from the bottom hinge .
To replace the doors, reverse the order of the above
instructions .
NOTICE: It is very important that all hinge screws are
securely tightened to ensure a secure assembly and
prevent hinge slippage . Do not overtighten the hinge
screws . Tighten them until they are just snug, and then
turn them another one-half turn .
NOTE: The door swing is not reversible .
Replacing the LED Light
The LED light is located behind a light lens in the celling
of the Freezer section .
To replace the LED light:
1 . Remove the top shelf (if necessary) .
2 . Gently push the three snap-in tabs at the front of
the lens, release the lens from the liner, and pull to
remove .
3 . Remove the LED assembly from the mounting tabs .
4 . Gently pull the leads out and disconnect from the unit .
5 . Replace with new LED assembly and slide assembly
back into mounting tabs .
6 . Replace the light lens by sliding the tabs at the back
of the lens into the slots and push up on the lens until
the tabs at the front of the lens snap into place .
To order the LED assembly, please call
GE Appliances at 800 .492 .2737 during normal
business hours .
10
Hinge
Screws
Light Lens in Freezer
LED Assembly
Plastic
Hinge
Cover
Wiring Connector
Top
Hinge
Disconnect Leads
49-1000101 Rev. 0