Time Fade; Set The Adjustable Time Fade; Set The Button Led Intensity - JOHNSON SYSTEMS CS-DMX Series User Manual

Time Fade

The control station is capable of fading from:
"OFF" "ON" "ON"
"OFF" "DIM" "DIM"
The control station is capable of pseudo fading from:
"DIM" "ON" "ON"
The control station automatically begins fading when a button is pressed. The button LED flashes
on and off once per second to indicate fading.
NOTE: Pressing a button or adjusting the master slider level while the control station is fading,
cancels the fade and immediately activates the button pressed.

Set the Adjustable Time Fade

The time fade can be adjusted from 0 to 60 seconds. The factory default time fade is 5 seconds.
NOTE: Be sure the local and remote lockout modes are deactivated before adjusting the time fade.
Procedure:
• To set the adjustable time fade, press and hold the "ON" button for approximately 10
seconds, until the "ON" LED extinguishes.
• Release the "ON" button and count the number of times the "ON" LED flashes on.
Each time the "ON" LED flashes on, 1 second of time fade is represented.
• Once the required number of times the "ON" LED flashes on is counted, press the "ON"
button to save the time fade and exit.
• To set the time fade to zero (no fading), press and hold the "ON" button for approximately
10 seconds, until the "ON" LED extinguishes. Release the "ON" button and immediately
press the "ON" button again before the "ON" LED flashes on.

Set the Button LED Intensity

The button LED intensity can be adjusted to a preferred intensity level for various environments.
NOTE: Be sure the local and remote lockout modes are deactivated before adjusting the button
LED intensity.
Procedure:
• To enter the button LED intensity adjust mode, press and hold the "ON" and "OFF" buttons
at the same time for approximately 10 seconds, until all the button LED's illuminate.
• Press the "ON" button to increase the button LED intensity. Press and hold the "ON" button
to accelerate the intensity adjustment.
• Press the "OFF" button to decrease the button LED intensity. Press and hold the "OFF"
button to accelerate the intensity adjustment.
• Once the preferred button LED intensity has been set, press the "ON" and "OFF" buttons at
the same time to exit the button LED intensity adjust mode and save the setting.
NOTE: There is a minimum button LED intensity so the control station will always indicate its
mode of operation/state.
www.johnsonsystems.com
"OFF"
"OFF"
"DIM"
9