Seco STARJET UJ102 Supplement To User’s Manual page 21

Fasten the linear motor (7) to the arms on the underside of the grass catcher. For
this purpose, use two studs and cotter pins. Then connect the prepared cables of the
electrical bundle to the motor.
3.3.3f
Slide the lid (10) on to the grass catcher and secure it in place using five ST6.3×7.9
bolts and rubber washers φ 6.4/14-1.2.
3.3.3g
Attach the face plate (11) to the frame of the grass catcher using two bolts 0-9016-
211.
3.3.3h
Attach two couplers (9) to the lateral sides of the grass catcher. For this purpose,
use four 0-9016-427 bolts and four M8 nuts. Slide the bolts in from the inner side of
the bracket, screw on the nuts from the outer side.
3.3.3i
Finally reattach the flexiglass cover (3), slide out the service rod (2) and put it back
into the holder on the lateral side of the frame.
Start up the machine and using the LIFT CATCHER switch lower the grass catcher
3.3.3j
to the bottom end position. Turn off the machine.
Using the supplied nuts and bolts, screw the ballast to the left and right side of the
machine's frame at the front underneath the bumper bar. This completes the assem-
bly of the grass catcher.
3.3.3k
21