Preparation For Putting Into Operation - Seco STARJET UJ102 Supplement To User’s Manual

3 | PREPARATION FOR PUTTING INTO OPERATION

3.1 | UNPACKING AND INSPECTING THE CONTENTS
In the packaging of machines with the high-dump grass catcher, you will find:
(1) Wooden pallet
(2) Ramps (attention – these are not included!)
(3) Grass catcher VK400 - disassembled
(4) Front ballast
3.1a
(5) Documentation (packed parts list, user's manual for the riding mower, user's man-
ual for the engine, user's manual for the battery, service log book)
3.3.3 High-dump grass catcher
For transportation reasons, the grass catcher was removed from the frame. Subsequently the lid and
the face plate were removed from the grass catcher. The front ballast was removed from the machine.
Reassemble as follows:
Start up the machine and using the "LIFT CATCHER" rocker switch, slide the carrier
(4) up the rails in order to gain access to the plexiglass cover (3). It is necessary to
hold down the switch for the grass catcher to move. Releasing the switch will stop
the movement of the grass catcher in any position of the grass catcher on the rails.
Then turn off the machine.
Slide the service rod (2) out of the holder and insert it into the hole in the moving
3.3.3a
rails to prevent the mobile frame from sliding down during the installation of the
grass catcher.
Then remove the plexiglass cover (3).
Screw the grass catcher bracket (5) to the carrier. For this purpose, use four M10×20
bolts and M10 nuts.
3.3.3b
Attach the electric bundle to the bracket underneath the grass catcher sensor (6)
using two M4×8 bolts and two M4 nuts, and connect it to the grass catcher sensor.
Also prepare the cables for connection to the linear motor.
3.3.3c
Place the grass catcher (8) on to the bracket and attach it to the bracket on the un-
derside using two bolts 0-9016-211 and connecting poles with threaded holes (the
pole is a part of the grass catcher).
3.3.3d
Slide stirrup clamp 0-1541-205 on to the connecting pole and fasten it to the central
pole of the bracket using two M8x40 bolts and M8 nuts.
3.3.3e
20