Boss ME-25 Turbostart page 2

®
b
Pedal FX
The ME-25's EXP pedal can control volume or other effects. To activate the Pedal FX:
1 Place the ME-25 on a hard floor surface.
2 While standing up, press the EXP pedal with your foot all the way toe-forward until
it stops, and then give it a stronger push. The PEDAL FX LED lights. When it's:
•
On—the pedal's controlling the Pedal FX.
•
Off—the pedal's controlling volume.
Edit Mode
You can edit any of the ME-25's memories to your liking. This includes turning on or off
specific effects, or editing effect parameters. In this example, we'll turn on and adjust
the delay.
1 Before using Edit mode, press the EXIT button.
2 Select a memory you'd like to edit.
3 Press the WRITE and EXIT buttons simultaneously.
4 Press the LEAD/DELAY button so it's flashing.
Turn the VARIATION/TYPE knob to 3—this selects the 3: 1000-6000ms DELAY
5
setting.
6 Turn the PARAM 1 knob to adjust the delay time, the PARAM 2 knob to adjust the
feedback, and PARAM 3 to adjust the delay effect level.
7 Repeat Steps 4-6 to turn on other effects and edit their parameters.
Tip: To turn off an effect, press the corresponding button so its LED isn't lit.
8 When you're finished editing, press EXIT.
©2010 Roland Corporation U.S.
ME-25
Guit ar Mul tiple Effects
www.BOSSUS.com
Storing Memories
Once you've edited a memory, you can save your custom settings by writing them into
any of the 60 memory locations. Here's how:
1 Edit a memory.
2 Press the WRITE button—the current memory number flashes.
3 Press the MEMORY 5 or 6 to select the location in which you'd like to store your
settings. If you'd like to write over the current memory, skip this step.
4 Press WRITE again.
TBS275 2