Table of Contents
Advertisement
Basic System Setup Diagram
Front-panel User Interface
Note that from any screen, pressing the ESC key twice will return you to the Home Screen.
Main-level Screens
Home Screen (rotates through data from each of the four RF
inputs)
R F 3 C H A N : 2 0
S N R 2 1 . 5 E r r S e c : 0 0 0 2
The channel number, modulation type (8VSB, 64QAM, or
256QAM), signal-to-noise ratio, and errored seconds are
displayed for each input.
Press the
4
key (if displayed) to go to Alarms/Warnings.
Press the ENT key to view the second-level Serial Number
and Application Software Version Number screen.
Alarms/Warnings
V i e w A l a r m s / W a r n i n g s
Press the ENT key to view any active alarms or warnings on
the second-level Alarms/Warnings Message screen.
4
Press the
key to go to Clear Errored Seconds (if counter is
non-zero) or Program Setup.
Press the ESC key to go to the Home Screen.
Clear Errored Seconds
C l e a r E r r o r e d S e c s
P r e s s < E N T >
This screen only appears if the errored seconds counter is
non-zero. Otherwise the next screen, Program Setup is
displayed.
Press the ENT to clear the errored seconds counter.
Press the
4
key to go to the Input Setup screen.
Press the
3
key to go to Alarms/Warnings.
Press the ESC key to go to the Home Screen.
800057-02 Rev. A
8 V S B
Page 2 of 11
Second-level Screens
Serial Number and Application Software Version Number
Screen
S / N : X X X X X X
V E R : Y Y Y
Where XXXXXX is the unit's six-digit serial number and YYY is
the version number of the unit's currently installed application
software.
Press the ESC key to go to the Home Screen.
nd
2
-level Alarms/Warnings Message Screen
N o A l a r m s o r W a r n i n g s
Any active alarms or warnings are described here.
4
Press the
key to view the next alarm or warning (if more than
one).
Press the ESC key to return to the Alarms/Warnings screen.
May 24, 2003
Advertisement
Table of Contents
