Table of Contents
Advertisement
22
Startup
Turn on the main switch
Turn the main switch in the ON position,
which are located at the rear end of the lift
next to the emergency pump.
Turn the key switch to the right to "I".
Check the battery indicator Battery level
(round indicator) on the chassis control panel
and also the emergency stop if it is activated.
Should be disabled.
Emergency stop (# 3) on the remote control
turned and released.
Start Button (# 1) held down for one second,
until there is red light in the indicator (# 2).
shown below boot image is displayed for a
few seconds.
Boot image with IDRC
Operators instructions
Boot image without IDRC
Depending on the mode switch (# 9)
position, one of the following three screens
will appear
Left - Lift Function
Middle - drive
935-33400011
FALCON
Operators Manual
Advertisement
Table of Contents
