Eneo AK-4 Quick Installation Manual page 13

Seal the unused holes with the supplied waterproof stoppers.
4) Screw the camera to the lid and push the seal into the screw connection.
Seal the opening by pulling on the cap.
5) Lay the cable parallel and wrap it around the winder. Secure the cables
with the supplied cable ties.
To make use of the VT-PS12DC-12 Power Supply (available separately)
insert the power supply and secure the power supply to the relevant screw
using the retaining clip thereafter.
Connect the camera via the rear-side cable entry, or with the M20x15 screw
cable gland. Check that the seals are sitting correctly and close the termi-
nal box. Secure the lid by tightening the screws.
Power supply assembly
Camera connection
DE
EN
FR
PL
RU
13