WilTec L02 Installation Manual page 8

Hardware kit:
Tools Required:

Phillips Head Screw driver

Stud finder for drywall installation
 Electric drill and 1/4" (8mm) masonry bit for concrete/brick installation
Note: You need to insert the bubble level system when you install the wall plate and take it
away fate you finish installation.
Step 1 – Mounting the Wall Plate
Wood Stud Installation
Note: Using a wood stud finder, locate the stud centers behind
the wall. Once found, make a pencil marking on the center of
the wood studs. Once the mark is made, it is strongly recom-
mended that a pilot hole be drilled with a 1/8" drill bit.
1. Place the wall plate against the wall with the hook towards the
bottom.
2. Secure the wall plate using one 2" wood screw (A).
3. Using the bubble level system (E), carefully adjust the wall plate
until it is level.
4. Attach the remaining 2" wood screw into the wall plate and tighten.
© by WilTec Wildanger Technik GmbH
http://www.wiltec.info
x2pcs 2" Wood
Screw (A)
x4pcs M4x12mm
Philips Head
Screw (B)
x4pcs M4x30mm
Philips Head
Screw (C)
x2pcs Concret
anchor（ H）
x4pcs 3/4" Spacer
(D)
x1pc Bubble Lev-
el System (E)
x1pc S=4mm
Allen Wrench (F)
x1pc S=3mm
Allen Wrench (G)
Seite 8