WilTec L02 Installation Manual page 10

Step 3 – Final Installation and Operation
Final Installation
1. To complete the installation, simply slide the arm piece onto the wall
plate.
2. The plastic tab on the top of the wall piece should click, indicating that
the arm piece is secure.
3. If you need to remove the arm piece, push in on the tab and slide the
arm up.
4. For additional security and stability, tighten the security bolt located on
base of the arm piece using the Allen Wrench (F) included in the hard-
ware kit.
Operation and Adjustment
NOTE: Adjustment of your LCD may vary by model.
On most models, the tilt angle of your LCD can be adjusted by first loosen-
ing the gear joint that holds the tilt in place. To do this, locate the adjust-
ment knob directly behind the LCD mounting point. Loosen it by turning the
knob counter-clockwise. Adjust the tilt to the desired level and re-tighten
the knob.
Other viewing adjustments can be made by simple moving the arm into the
desired position. If you find that a joint is too difficult to move or does not
hold the LCD in place, you can adjust the tightness of the joint. If your
mount includes black adjustment knobs, turn a knob clockwise to tighten
and counter-clockwise to loosen. If your mount does not have knobs, use
the Allen Wrench (F) to tighten or loosen the joint.
© by WilTec Wildanger Technik GmbH Seite 10
http://www.wiltec.info