Advertisement
HOW TO STOP YOUR UNIT
Push and hold the engine stop switch in the
or
position until the unit has fully
STOP
OFF
stopped.
Choke lever
Trigger
Primer Bulb
HOW TO START YOUR UNIT
WARNING:
The trimmer head will turn
while starting the engine. A hot muffler can
cause serious burns.
COLD ENGINE STARTING OR
STARTING AFTER REFUELING
S Set unit on a flat surface.
S Slowly press the primer bulb 6 times.
S Move choke lever to FULL CHOKE posi-
tion.
S Squeeze the throttle trigger fully and hold
through all remaining steps.
S Pull starter rope handle sharply 6 times.
S Move choke lever to HALF CHOKE posi-
tion.
S Pull starter rope handle no more than 6
pulls, until engine runs.
S Allow engine to run 10 seconds, then move
choke lever to OFF CHOKE position.
RESTARTING A WARM ENGINE
S Move choke lever to
OFF CHOKE
S Pull starter rope handle until engine runs.
S If engine does not start in 5 pulls, follow
instructions in STARTING A COLD EN-
GINE.
USING YOUR UNIT
OPERATING POSITION
ALWAYS WEAR:
Long Pants
Heavy Shoes
Cut from your right to your left.
ADVANCING THE CUTTING LINE
Advance line by tapping the bottom of the cut-
ting head lightly on the ground while engine is
running at full speed. The metal Line Limiter
blade attached to the shield will cut the line to
the proper length.
REPLACING THE LINE
S Push and hold the engine stop switch in the
stop/off position until the unit has fully
stopped.
S Disconnect the spark plug lead wire.
S Remove spool by firmly pulling on tap but-
ton.
S Clean entire surface of hub and spool.
S Replace with a pre-wound spool, or cut two
lengths of 12-1/2 feet of .080" (2 mm) diam-
eter Weed Eaterr brand line. Never use
wire, rope, string, etc., which can break off
Muffler
and become a dangerous missile.
S Insert ends of the line about 1/2 inch (1 cm)
into the small hole on the inside of spool.
Spool
Line exit holes
Hub
S Wind the line evenly and tightly onto the
position.
spool. Wind in the direction of the arrows
found on the spool.
S Push the line into the notches, leaving 3 to 5
inches (7 -- 12 cm) unwound.
S Insert the line into the the exit holes in the
hub as shown in the illustration.
S Align the notches with the line exit hole.
S Push spool into hub until it snaps into place.
S Pull the line extending outside of the hub to
release it from the notch.
Eye
Protection
We recommend all service and adjustments
not listed in this manual be performed by an
Authorized Service Dealer.
CARBURETOR ADJUSTMENTS
Your carburetor is equipped with limiter caps.
Carburetor adjustment is a complicated task.
We recommend that you take your unit to an
Authorized Service Dealer. Damage will oc-
cur if you turn the needles beyond the limiter
stops.
IGNITION TIMING
The ignition timing is fixed, non-adjustable.
SPARK PLUG
Replace the spark plug yearly using a Cham-
pion RCJ--8Y plug. Spark plug gap is 0.025".
4
Small
Holes
Line in Notch
Line in Notch
SERVICE
Advertisement
