Kenwood AT281 Instructions Manual page 5

121160 Iss 1 AT281_AT286 multilingual:18286 Iss 2 HB750 multi
Mill AT286
(if supplied)
Use the mill for milling herbs, nuts and coffee beans.
safety
Don't touch the sharp blades. Keep the blade unit
G
away from children.
Only use the jar and the blade unit with the base
G
supplied.
Never blend hot liquids in the mill.
G
Never remove the mill until the blades have
G
completely stopped.
Never attempt to fit the blade unit to the machine
G
without the jar fitted.
When removing the mill from the power unit, care
G
should be taken not to unscrew the milling jar from
the base assembly.
To ensure the long life of your mill, never run for longer
G
than 30 seconds. Switch off as soon as you have got
the right consistency.
G The processing of spices is not recommended as they
may damage the plastic parts.
The appliance will not work if the mill is incorrectly
G
fitted.
G Use for dry ingredients only.
key
base
blade unit
sealing ring
milling jar
to use the mill
1 Put your ingredients into the jar.
2 Ensure the sealing ring is correctly fitted on the blade
unit.
3 Turn the blade unit upside down. Lower it into the jar,
blades down.
4 Screw the base onto the jar until it's finger-tight.
5 Remove the high speed outlet cover by turning anti
clockwise and lifting off
6 Place the mill onto the outlet with the arrow
mill base towards the back of the machine. Turn the
mill clockwise to lock firmly into place until the two
arrows align .
7 Switch on to maximum speed.
The attachment will not operate if it is
G
incorrectly assembled or incorrectly fitted
to the kitchen machine or if the medium
speed outlet cover is not fitted.
.
on the
8 Once the desired consistency has been achieved
switch off and unplug.
9 Remove the mill.
10 Refit the high speed outlet cover after use.
hints
G Herbs are best milled when clean and dry.
When milling coffee beans, the longer the running
G
time the finer the result.
The maximum capacity for herbs is 10g and nuts and
G
coffee beans 50g.
care and cleaning
Always switch off and unplug before removing the
G
attachment from the kitchen machine.
Dismantle the attachment fully before cleaning.
G
For easier cleaning always wash the parts immediately
G
after use.
jar, base
Wash by hand in hot soapy water.
The jar and base may also be washed in the
dishwasher.
blade unit
1 Remove and wash the sealing ring.
2 Brush the blades clean under a tap. Keep the
underneath of the unit dry.
3 Leave to air dry.
6
A5 26/2/13 08:36 Page 6