TRACKIMO Guardian User Manual page 2

Before first use of Trackimo Guardian
Place the device in an open space that does not interfere with GSM / GPS connections for approximately 15
minutes. This process is required to properly calibrate the GPS location module.
After proper calibration, the device will be able to locate itself via GPS within seconds when entering open space.
Now you are ready to activate your device.
How to acivate Trackimo Guardian ?
First you will need to create an account on the Trackimo platform. To do this, go to the trackimo.pl website and then
in the upper left corner of the page click the "Register" button. Enter the email address, set the appropriate
password (from 6 to 10 characters), enter the phone number if you want to receive SMS notifications (not required).
After entering all the necessary information, confirm the registration by clicking again on "Register".
At the e-mail address provided in the registration process you will receive a confirmation message on the Trackimo
platform, to activate your account open the message and click on the "click here" button. Now you can log in to your
Trackimo account at trackimo.pl by selecting "Login" in the top left corner.
Note: do not forget to check the SPAM folder if there is no message in the main mail folder.
Now you are ready to activate your device.
To do this after logging in to your Trackimo account via trackimo.pl, in the upper left corner click on the "+ Add
Device" button, in the new window enter the device ID number and the last 4 digits of the IMEI number. The device
ID and IMEI number can be found on the sticker on the back of the and on its packaging. When adding a device you
can freely name or tag it to make it easier to recognize it on the device list, if you wont change it'll be named by
defaut as its ID numer, you can change in later in the device settings.
Checking device status
At any time, you can check whether the device is currently on or off, to do it once press the power button (1), if any
of the LEDs on the device turns on, it means that it was turned on, if no LED lights up, the device is turned off .
You can also do this by sending a pre-defined message (3) and (5) or SOS notification (6), after pressing the buttons
(3), (4) or (5) for about 3 seconds, the green LED on the device will light up (6) if it does not, it means that the device
is currently turned off.