User Guide v7 1. Getting Started 1.1. Unpacking Your Device Carefully unpack your Trackimo device. Your packaging should include: • Battery • Locking Belt Clip • Adhesive Velcro • Adhesive Magnet • Water Resistant Sleeve • USB Cable • Screw Driver •...
“Log In” and then “Sign Up”. Enter your email, choose a password, re-enter the password and click on the “Sign Up for Trackimo” button. You will receive a confirmation email to validate your email address. From this point on you can login through www.trackimo.com.
Page 5
User Guide v7 Initial Activation Screen Identify the “Device ID” of your Trackimo. This is a 7-digit number, located on the inside of your Trackimo under the battery, and printed on the package. Enter this number. After you enter the device ID, the system will check the connectivity of your...
Page 6
User Guide v7 If your Trackimo is not properly connected to the cellular network, you will see this: In case the device is not connected to GSM network, you will be asked to perform a few short steps and retry the connection.
Page 7
User Guide v7 Your Trackimo device includes a prepaid 12-month monitoring subscription. You are not required to enter payment information at this time. Congratulations, your device was successfully activated! The only thing left to do is personalize your Trackimo device.
User Guide v7 Enter a nickname for your Trackimo device and (optionally) the phone number to receive alerts and notifications directly to your phone. Now you are ready to go. REMEMBER: The device has to be fully charged before the first activation.
User Guide v7 1.7. Your Device Lights and Sounds To provide you with a richer visual and audio experience, the device will display lights and make sounds. The picture below shows where all the buttons and lights are located on the device and the table below shows what causes these lights and sounds to occur.
2. Trackimo Dashboard 2.1. Dashboard Overview After logging in to the Trackimo website with your username and password, you will reach the Trackimo dashboard. The image below depicts the Trackimo dashboard with a short explanation in the table below about the key items within the dashboard.
Page 11
User Guide v7 Notification Menu Alerts the user to the number of unread device notifications, and upon clicking the menu shows all device notifications. User Menu Upon clicking provides user specific options such as logging out or activating another device. Device Location Provides location,...
User Guide v7 2.2. Device Location Information The device information can be found in two places: 1. When clicking on the device marker icon on the map, the location information will be available inside the information pop up right above the device marker icon.
Trackimo will retrieve an exact GPS-based location, but if GPS is unavailable at the device location, Trackimo will attempt to approximate the location using the mobile network signals to the device.
User Guide v7 The device will update its location every 5 minutes; this mode 5 Minutes will cause the device to have a short battery life. The device will update its location every 30 minutes; this 30 Minutes mode will cause the device to have a moderate battery life. The device will update its location every 120 minutes;...
Clicking on the device alarms will open a settings menu on top of the screen. This will allow you to set the device’s specific settings and alarm notifications. Alarms are sent to your configured email and to the Trackimo dashboard. The notification alarms will include the device’s location and speed at the time the alarm is triggered.
Page 16
Icons Sending Alarms to contacts The Trackimo service allows you to send alarms you may receive to other contacts through their email address or as an SMS alarm to their cell phone. This can be done by clicking on the “Add contacts for this alarm” link below each alarm.
User Guide v7 2.7. Manage Subscription Renewals Clicking on the Manage Subscription link will open the following popup on top of the screen. This will allow you to see subscription information and perform actions such as “increase your monthly text alerts limit”. Subscription information includes: Start and end dates of your current subscription per device •...
A GeoFence is a virtual fence (a rectangle around a certain location) that you can set using the Trackimo dashboard. When the device crosses the virtual fence, you will receive an email alarm message with information of when the device has crossed the virtual fence.
Page 19
User Guide v7 To setup a GeoFence: 1. Click on the Fence button in the device menu. 2. Click on the "Create a new fence" button, this will open the new fence options below the button. 3. You will then have the option to search for an address for your fence and set a perimeter.
Need help?
Do you have a question about the Universal Tracker and is the answer not in the manual?
Questions and answers