Table of Contents
Advertisement
Hexagon Socket Head Cap Screw
(M4 x 16)
Fig. 13
11 . BREAK-IN PROCEDURE
During transportation, storage or installation, the grease inside the bearings will settle. If the Motor Spindle is
suddenly run at high-speed, the grease will be ejected from the bearings, causing excessive heat that will cause
bearing damage.
After installation, repair, initial operation, or long periods of non operation, please follow the break-in procedure
detailed in Table 2.
Table 2.
Steps
-1
Rotation Speed (min
) (rpm)
Rotation Time（min）
Items to Check
12 . CAUTIONS WHEN USING GRINDSTONES AND TOOLS
CAUTION
The maximum surface speed or rpm is always specified for a grindstone. Do not exceed the
maximum speed with reference to the calculating chart below. Always follow the grindstone
manufacturer's recommendations.
Surface Speed (m/s)
① The proper surface speed for general grindstones is 10-30m / s.
② Do not exceed 13mm of overhang for mounted grindstones as shown in Fig. 15. If the overhang must exceed
13mm, reduce the brushless motor speed in accordance with Table 3.
③ Dress the grindstone prior to use.
④ Do not use cutting tools with bent or broken shanks, cracks or excessive run-out.
⑤ For grinding, the maximum depth of cut should not exceed 0.01mm radially or axially. Reciprocate the tool
several times after each pass to eliminate tool pressure.
⑥ Always operate cutting tools within the allowable recommended speed of the cutting tools. Use of a cutting tool
outside of the allowable speed of the cutting tools could cause damage to the Spindle and injury to the operator.
Fastening Bolt
Split Type Holder
1
2
15,000
30,000
15
10
No Abnormal
The Motor Spindle housing temperature during the
Noises.
break-in process should not exceed 20 degrees C
(36 degrees F) above ambient temperature. Should
the Motor Spindle exceed this limit, rest the motor
spindle for at least 20 minutes and re-start the break
in procedure from the beginning. If the housing
temperature rises again and exceeds 20 degrees C
(36 degrees F) above ambient temperature, check
the Motor Spindle for proper installation.
3.14 x Diameter (mm) x rotation speed (min
=
Slit of Bushing
Fastening Bolt
Slit
Bushing with Slit
Fig. 14
3
4
40,000
50,000
10
10
1,000 x 60
Fastening Bolt
5
60,000
10
The Motor Spindle
housing temperature
during the break-in
process should not
exceed 25 degrees
C (45 degrees F)
above ambient
temperature.
) (rpm)
-1
15
Advertisement
Table of Contents
