Witter SK29U Fitting Instructions

Available languages

MATERIALS

Cross Bar

Side arms

M12x35 Bolts, Lock Washers 30mm Washers and Cage nut assembly.

M12x35 Bolts, Lock Washers and Nuts.

Electrical socket Plate.

Chosen neck option.

1. Remove light clusters (2 nuts per cluster in luggage compartment).

2. Remove bumper (3 torque screws in each wheel arch and 3 screws underneath bumper).

3. Remove crash beam (hand to customer).

4. Remove square sections of tape on chassis rails to reveal mounting points.

5. Fit Witter cage nuts to both side arms.

6. Fit side arms loosely using fixings "D" then attach cross tube using fixings "E".

7. Fully tighten all fixings to correct torque setting.

8. Cut bumper and then re-fit.

Note: This towbar must be used with either a Witter Towball (part number Z11) or Class A50-1 or A50-X towball dimensionally

Conforming to A50-1 with a 'D' and 'S' value greater than or equal to that of the towbar.

Recommended torque settings: Grade 8.8 bolts: M8 - 24Nm, M10 - 52 Nm, M12 - 80 Nm, M14 - 130 Nm, M16 - 200 Nm

Grade 10.9: M12 – 120Nm, M10 – 70Nm M8- 35Nm

Witter-towbars.co.uk

Fitting

Instructions

W 0 0 0 1 S K 2 9 U -F IT $ 0 1 1 5 0 8 2 5 0 0 0 0

For Skoda Fabia Hatch 2015-

#NAME?

TOWBAR

SK29U

Issue 1

Table of Contents

Do you have a question about the SK29U and is the answer not in the manual?

Page 1 8. Cut bumper and then re-fit. Note: This towbar must be used with either a Witter Towball (part number Z11) or Class A50-1 or A50-X towball dimensionally Conforming to A50-1 with a ‘D’ and 'S' value greater than or equal to that of the towbar.
Page 2 8. Découper le pare-chocs en vous servant du schéma ci-dessous comme guide uniquement et remonter le. Remarque : Cet attelage doit être utilisé avec une boule de remorquage Witter (référence produit Z11) ou une boule de remorquage Classe A50-1 ou A50-X se conformant dimensionnellement à A50-1 avec une valeur ‘D’ et 'S' supérieure ou égale à celle de l’attelage.