Table of Contents
Advertisement
Available languages
Available languages
·
Place the portafilter under the brew group. Hold the handle so that it connects correctly to the open-
lock symbol
·
Turn it slowly to the right, to the closed-lock symbol
·
Once the appliance has been preheated, the indicator lights of the espresso and double espresso
button will light up. Turn the selection button to the coffee symbol
·
Place a cup under the drip catcher and press one of the lit up buttons for a small cup or a large cup.
By default, the espresso button fill a 40ml cup, the double espresso button an 80ml cup. Consult the
heading "setting capacity" to program the standard amounts differently.
·
The coffee will run through and the indicator light on the selected button will flash. When the coffee is
ready, both indicator lights will light up. If you want to stop the appliance before it is done, press the
selected button again while the coffee is running.
·
Remove your cup from under the portafilter. Turn the selection button to the middle position "0".
A small amount of water may be deposited into the drip catcher via a hose at the bottom of the
appliance. This is normal.
·
Remove the portafilter from the appliance. Place the retainer clip against the filter and bang the coffee
grounds out of the filter.
·
Clean the portafilter and dry it off for the next use.
MILK
·
Put the plug in the socket and press the on-off button.
·
Turn the selection button to the middle position "0". Press the steam button to heat up the appliance.
The indicator light will flash. Once the indicator light stays on, the appliance is heated.
·
While it is heating up, a small amount of water may end up in the drip catcher. This is normal.
·
Fill a small jar with cold milk (not hot!). Be careful not to fill it too full. When the milk foams, it
increases in volume. Place the jar under the steam pipe.
·
Turn the selection button to the steam symbol.
·
Immerse a few millimetres of the steam pipe into the milk. To get creamier foam, immerse the steam
pipe in the milk and rotate the jar with slow movements from the bottom to the top.
·
Once you have the desired amount of foam, turn the selection button to the middle position "0".
·
Clean the steam pipe after each use. Caution: the steam pipe may still be hot.
HOT WATER
·
Put the plug in the socket and press the on-off button.
·
Turn the selection button to the steam symbol.
·
Place a cup under the steam pipe.
·
Press the espresso button.
·
When you have enough water, turn the selection button to the middle position "0".
SETTING THE CAPACITY
By default, the espresso button fills a 40ml cup, the double espresso button an 80ml cup. You can program
26
DO711K
on the appliance and fits into the groove.
on the appliance.
.
Advertisement
Table of Contents
