Maintenance - Worx WA3742 Manual

Green
Flashing
Green ON
Red Flashing
Red ON
NOTE:
1. The charger will not automatically switch
off when the battery is full charged. Do not
leave your battery on charge continuously.
This may damage the battery cells.
Do not overcharge any batteries.
WARNING: After long usage the
battery will become hot. Let the hot
battery cool down for at least 0.5 hour
before recharging.
2. Do not charge a battery when it too hot or
the air temperature is blew 4
3. In a warm environment or after heavy use,
6
the battery pack may become too hot to
permit charging. Allow time for the battery
to cool down before recharging.
When the battery is charged for the first
time and after prolonged storage, the
battery will only accept approximately
60% charge. However, after several charge
and discharge cycles the battery will
accept a 100% charge.
4. It must be charged for 12 hours before
using the first time!
5. When charging is completed, unplug the
charging plug form the wall socket.
WARNING: Shock hazard. Don't
allow any liquid to get inside
charger. Electric shock may be the result.
CAUTION: Never attempt to open the battery
pack for any reason. If the plastic housing of
the battery pack breaks or cracks, return to a
service center for recycling.
STORAGE RECOMMENDATIONS
1. The best storage place is one that is cool
and dry away from direct sunlight and
excess heat or cold.
2. If the battery pack will not be used for
Battery Charger
Charging
Fully Charged
The temperature
of battery pack
is less than 32°F
(0°C) or more than
113°F (45°C).
Defective Battery
C.
o
a long time, it is best to make sure it is
properly stored. Make sure it is half or
fully charged before storing. The battery
should be stored in an area that maintains
a temperature of approximately 65°F and
75°F (18°- 24°C). Long term exposures to
hot temperatures are hazardous to the
battery packs life. Additionally, the battery
pack should be charged at least once a year.

MAINTENANCE

ROBLEMS AND SOLUTIONS
1. I CANNOT FIT THE BATTERY INTO THE
BATTERY CHARGER. WHY?
1) Check if the charger and the battery pack
are specifically designed for working
together.
2. REASONS FOR DIFFERENT CHARGING
TIMES
The charging time can be affected by many
reasons which are not defects in your product.
1) If the battery pack is only partly discharged
it may be re-charged in less than 5 hours.
2) If the battery pack and ambient
temperature are very cold then re-charging
may take more hours.
3) If the battery pack is very hot you must
remove your battery pack from the charger
and allow your battery pack to cool first to
ambient temperature and then recharging
can be started.
NOTE: The charging time can be affected by
many reasons which do not indicate defects in
your product.
Remove the plug from the electrical
socket before carrying out any
adjustment, servicing or maintenance.
Your tool requires no additional lubrication
or maintenance. Never use water or chemical
cleaners to clean your tool. Wipe clean with a
dry cloth. Always store your tool in a dry place.
EN