Advertisement
ASSEMBLY GUIDE
STAGE 60: PREPARE
AND FIT ROBI'S
HEAD SERVOS
Prepare Robi's second head servo then fit it, along with the
one from the previous stage, to his head servo frame.
There are two servos inside the upper
part of Robi' s head, ID=14 and ID=15.
Both are set onto the head servo
frame that you fitted and wired over
the previous stages, and they will work
in tandem with the internal lever and
SAVED PARTS
head base to make Robi' s head tilt
forward and back (in the case of
ID=15) and side to side (ID=14). As
ever, take care when handling open
servos, and make sure you set the
correct ID number.
1
You will be using parts from the
previous stages, so be sure to have
these to hand before beginning.
Neck stand
(Stage 53)
PARTS TO BE
ASSEMBLED
YOUR PARTS
1 Servo motor (ID=14)
Power distribution board
(Stage 40)
Battery
(Stage 38)
328
Body and neck assembly, and
servo cable (Stage 59)
Advertisement
