Before use
Fitting/changing the sander plate
WARNING!
►
Always remove the plug from the mains
power socket before carrying out any work
on the appliance.
♦
Use the appropriate sander plate
the corresponding application.
♦
Remove the four screws
4a
hex key
.
♦
Remove the pre-fitted sander plate.
NOTE
The orbital sander plate
the appliance in one direction. Please pay at-
tention to the arrow marks on the orbital sander
plate
. These must point forwards. With the
delta sander plate
♦
Now fit the required sander plate. Ensure that
the mounting plate B is aligned with the sander
plate. The threaded holes of the mounting plate
B must be aligned with the corresponding holes
on the respective sander plate. Align the rubber
pins A
(only on sander plates
with the holes in the appliance (see fig. 1).
A
B
Figure 1
♦
Replace the four screws
♦
Check that the sander plate is fitted securely.
│
GB │ IE
■
18
using the supplied
can only be fitted to
the tip points forwards.
and
using the hex key
Selecting a sanding sheet
Removal and surface:
The material removal rate and surface quality are
determined by the grain strength of the sanding
sheet.
♦
Please note that you need to use appropriate
sanding sheets with different grains for working
for
different materials.
Fitting the sanding sheet
WARNING!
►
Always remove the plug from the mains
power socket before carrying out any work
on the appliance.
NOTE
►
Before fitting a new sanding sheet, remove any
dust and dirt from the sander plate
Attaching sanding sheets using Velcro:
♦
You can attach the sanding sheet to the sander
plate
♦
Ensure that the extraction holes on the sanding
sheet match up with those on the sander plate.
)
Removing sanding sheets fitted using Velcro:
♦
Simply pull the sanding sheet off the sander
plate
Attaching sanding sheets without using
Velcro (see fig. B on the fold-out page, not
supplied):
♦
Open the two clamping levers
♦
Push the sanding sheet under the open clamp-
ing rail
at one end and clamp it firmly in
place with the clamping lever.
4a
.
♦
Follow the same procedure at the other end.
using Velcro.
(see fig. A on the fold-out page).
.
PMFS 200 C3
.